NEW! Added
Features:
- Easy 4 button programming with newly developed logic
- 5 Basic Programs selected by scrolling up or down
- Charge 1-26 cells NiCad or NiMh 100mAh-5000mAh
- Discharge 1-26 cells NiCad or NiMh 0.1A -5A
- Cycle Mode 1 First Charge then Discharge
- Cycle Mode 2 First Discharge then Charge
- Parameter Setting Display lets you adjust:
-Delta Peak Sensitivity for NiCad (5-15mV)
and NiMh (3-10mV) batteries separately
-Trickle Charge Rate Setting from 0 mAh to
250 mAh after Fast Charge is completed
- Precision Voltage Reading in 1 Thousand of one Volt
|
|
Readout after charging or discharging gives
information for Quality of Battery:
- Delta Peak Point,
- Elapsed Charge time
- Average Voltage under load
- Accumulated Charge (What is stored in your
battery)
- How good is your battery ?. Keep a record
and compare the data after several charges.
|
|
|
NEW! Added
Battery Charging Safety features:
- Temperature and load watch in the DYMOND SUPER TURBO
Charger regulates the Cooling Fan inside.
- Temperature watch will cut off unit when it gets too hot.
- Optional Temperature Probe ($ 14.95) can be strapped to
battery and will trigger a "Completed Charge" message and
cuts off when the battery gets too hot. Excellent safety feature for
unknown battery types.
- Maximum Charge Limit. The maximum charge can be
programmed. If you have a 2000 mAh battery, then program a save stop
at 2400mAh. Reaching 2400 mAh accumulated charge would turn the
charger off in case the Delta Peak Point was too vague and could not
be detected.
|
