Power-Pro Stunt Tank

Stunt Tank (No Clunk)
The unique Delrin Mount on the Precision RC Products Stunt tank, as noted in the first photo above, allows the tank to mount to most frame situations with plenty of clearance. It can be reversed so the standoff is high or low. This gives you much more choice as to where you can mount the tank. The wide foot design of the Delrin Mount will keep the tank where you put it. It won't tip or tilt, unless you want it to. Use Offset-High or Offset-Low to accommodate most any configuration or frame clearance situation.

The "Lock Screw", as shown in the second photo above, can be used to insure that your tank never slips out of the mount in extreme 3D flying. Simply screw into the tank from the side access hole in the Delrin Mount. Use medium tightening to lock into place. Will not leak This Stunt Tank Setup uses stand off pipe configuration for true Stunt Tank performance. The main feed line direct to the carb from the Stunt Tank is placed in the Stunt Tank exactly in the middle of the tank as viewed from all directions. There is NO fuel line and clunk attached inside the tank to this feed line.

Kit includes several inches of PRCP EZ-Line - the heat bendable fuel line that takes the place of brass tubing. Can be heat bent to almost any configuration. No more cut lines from sharp edges of brass tube. (brass tube is included for your choice of use). Note: A clunk line can be added for use as Aux Tank setup if desired. (clunk pieces not included) Instructions included.